Ford Torino Rear Suspension Installation

Ford Torino Rear Suspension Installation 

1. The front crossmember locates with the spring perch holes. Make sure that the crossmember is square before welding.
tor01
tor02
2. Cut section of the floor for the rear crossmember.
tor03
3. The center of the rear to the center of the coil over cross member is 4 ½ “
tor04
4. This is the pan hard bracket welded to the frame
tor05
5. This is the 9” rear end bracket for the pan hard
tor06
These are more photos for your reference
torino_rrins01  torino_rrins02  torino_rrins03

torino_rrins06 torino_rrins05 torino_rrins04